Sometimes the O2 sensor port plug is a little long.
This will not cause problems, but you can get
a little more flow by perfectly matching it to the port size.
This will require cutting/filing the O2 port plug/bolt.



These are all of the parts that are included
with the typical Street Style headers.

Install Information

This shot also show part of an upgraded flexpipe
and Jet-Hot coated RPW 1.8 Street headers

Another shot of the finished system

Here is an example of where the Street headers usually end
in relation to the stock exhaust system.

This picture shows the end of the stock flex-pipe stuffed into the end of the headers. This should work fine to get to the muffler shop. Be sure to use some wire as a temporary hanger if it does not seem stable.